Site Preparation and Grading

Site Preparation and Mass Grading in Waco

Every commercial build starts the same way: the raw parcel has to be shaped to the engineer’s grading plan before anything vertical goes up. Grandprojects2021 strips and stockpiles the topsoil, moves the cut and fill to balance the site, and grades from rough to finish so the pad elevations, drainage slopes, and compacted subgrade all land where the plan calls for them. On a large lot near Valley Mills Drive, that earthwork takeoff is what keeps a project from ordering 400 loads of import dirt it never needed.

Why Mass Grading Is a Precision Job

Commercial grading is measured in cubic yards, and small elevation errors multiply fast across an acre. We run laser and GPS machine grade control on our dozers and excavators, so a finished subgrade matches the design surface instead of being chased by hand. A balanced cut and fill also holds down cost, because dirt that stays on site is dirt you are not paying to haul in or out.

Our Process

We start from your stamped grading plan and geotechnical report. Silt fence and inlet protection go in first to satisfy the SWPPP on any site over one acre. Then we strip topsoil, move the earthwork to grade, and compact the subgrade to spec, verifying with a nuclear density gauge referenced to a Standard Proctor. You get a level, drainable, build-ready pad and the density documentation to prove it.

Call (254) 806-0562 for a written proposal on commercial site prep and grading in Waco.